原子在单色辐射作用下长时间内的行为研究

建立了原子在单色辐射作用下的模型，用微扰理论方法求解出原子处于两能级的几率.讨论了原子在单色辐射作用下长时间内的行为，得到了原子因辐射场的影响而变化的速率比能级的衰减速率大的情况下，原子在两能级间振荡，原子和辐射场相互作用越强，辐射场能够与原子发生作用的频率区间越宽,而且原子在单色光长时间辐射作用下高、低能级跃迁的速率不随时间而改变的结论.     

高聚物与光场相互作用的微观机制

分析光场与高聚物相互作用的微观机制，介绍高分子与小分子在光场作用下的极化过程。对在窄束光场作用下，高分子链极化后链上各处极化程度的分布情况进行研究，指出对于高度拉伸的聚合物薄膜，电偶极子模型不适合准确解释高分子与光场相互作用的微观机制。为此，采用符合实际的天线模型分析高分子天线与窄束光场的相互作用，从理论上推导出天线模型高分子链上一小段的极化公式，并用离散变分方法——DVM（discrete variational method）计算一个高分子链的极化分布，验证了文中推导出的分式的合理性。最后，将极化分布看作是电流在天线上的分布，计算了天线的次级辐射在空间中的角分布，得到天线模型对电偶极子模型的修正因子。     

多边形棒状透镜出端辐射均匀性的研究

研究了用多角形棒状透镜产生高均匀性正方形和圆形照明的最佳结构参量.结果表明,对于正方形棒状透镜,输出端的照明均匀性随透镜的长度振荡变化,在某些特定长度达到极小值.对于圆形照明面积,比较了从三角到八角的六种多边形.利用三角形积分透镜可以获得最佳的照明均匀性,但光能利用率相对较低,六角形积分透镜可同时获得较高的照明均匀性和光能利用率.     

硬X射线磁圆二色实验方法的建立

在北京同步辐射装置(BSRF)1W1B光束线和XAFS实验站上国内首次建立了硬X射线波段的磁圆二色实验(XMCD)方法. 以单晶金刚石作为相位延迟片, 在透射劳埃(Laue)模式下, 利用衍射双折射效应, 将入射的单色线偏振光转变为相应的左旋和右旋圆偏振光, 测量磁化样品对左旋和右旋圆偏振光吸收的差异, 获得了XMCD信号. 本实验使用透射方法测量了Pt-Fe合金Pt L_2,3边的XMCD, 获得了XMCD信号. XMCD实验方法的建立, 为研究磁性材料尤其是磁性薄膜材料的电子结构和磁结构提供了实验基础.     

Modification of the surface state of rough substrates by two different varnishes and influence on the reflected light

Modification of the visual appearance when a rough surface is covered by a varnish is mostly attributed to the levelling of the substrate surface, which depends on the molecular weight of the varnish. The topography of varnished surfaces, however, has never been measured directly. Surfaces of varnishes applied over glass substrates of varying roughness were studied, therefore, using mechanical profilometry. Two different varnishes made with a low and a high molecular weight resin were studied. Both varnishes lower the r.m.s. roughness of the substrates and filter the high spatial frequencies. These results are amplified for the varnish containing the low molecular weight resin. The light reflected by the varnished samples is modelled from these topographical data. Its angular distribution, calculated from the probability density of slopes is presented, taking into account separately the air/varnish and the varnish/substrate interfaces. These analyses are presented in a back-scattering configuration. They show that varnishing significantly reduces the angular width of the reflected light and that this effect is magnified for the low molecular weight resin. Modelling furthermore shows that the influence of the roughness of the varnish/substrate interface is negligible in the total reflected light.     

一维光学格子孤子的传输特性及控制研究

利用解析和数值方法研究了在具有横向折射率周期性调制的克尔型非线性介质中光学格子孤子的传输，得到了孤子参数的演化方程以及格子孤子的形成和稳定传输的条件.结果表明：当光束的入射角小于某临界角度时，光束可被类似波导形式的路径俘获而稳定传输，该临界角随折射率调制周期、调制深度的增加而增大，且光束越窄临界值越大.此外，线性空间啁啾虽然对光束传输的中心位置没有任何影响，但会导致光束发散从而破坏格子孤子的形成和稳定传输，对此提出了采用特定功率取值来补偿啁啾作用从而形成格子孤子的方案. 关键词： 光孤子 光学格子 光传输 矩方法     

Compulsorily Phase Locked Interferometer Using Orthogonally Polarized Light Source of a Modulated LD with High Extinction Ratio

This paper describes a compulsorily phase locked differential interferometer using an orthogonally polarized light source of a modulated LD with high extinction ratio to reduce non-linearity of the interferometer caused by polarization cross-talk. The current modulated LD is used as a light source to make the interferometer compact and for the scanning phase of the interferometer. The interferometer is operated compulsorily at the maximum inclination point of the fringe intensity curve by fringe scanning and an electric system. A Wollaston prism of high extinction ratio (50 dB) is used to combine the polarizing beams and to make the polarization cross-talk very small. In one light source the polarized output beams are on the same propagation axis; in the other they have a small crossing angle (2.5 mrad ∼ 10 mrad) to completely exclude non-linearity of the interferometer causded by polarization cross-talk. Using jets of a gas mixture of nitrogen and ethylene, this interferometer was demonstrated to be useful in detecting the photothermal effect of a photothermal velocimeter under phase fluctuation in a turbulent flow.     

波片复合旋光器研究

利用矩阵光学方法，分析了波片复合旋光器的理论基础，给出了二元和三元复合波片旋光器的条件及其旋光角的大小的数学表达式，并根据此理论作了典型设计。结果表明，旋光角的大小与各波片的延迟量和它们的快轴同X轴的夹角有关。     

Crystallization and morphology of poly(vinylidene fluoride)/poly(3‐hydroxybutyrate) blends. I. Spherulitic morphology and growth by polarized microscopy

The development of the poly(3‐hydroxybutyrate) (PHB) morphology in the presence of already existent poly(vinylidene fluoride) (PVDF) spherulites was studied by two‐stage solidification with two separate crystallization temperatures. PVDF formed irregular dendrites at lower temperatures and regular, banded spherulites at elevated temperatures. The transition temperature of the spherulitic morphology from dendrites to regular, banded spherulites increased with increasing PVDF content. A remarkable amount of PHB was included in the PVDF dendrites, whereas PHB was rejected into the remaining melt from the banded spherulites. When PVDF crystallized as banded spherulites, PHB could consequently crystallize only around them, if at all. In contrast, PHB crystallized with a common growth front, starting from a defined site in the interfibrillar regions of volume‐filling PVDF dendrites. It formed by itself dendritic spherulites that included a large number of PVDF spherulites. For blends with a PHB content of more than 80 wt %, for which the PVDF dendrites were not volume‐filling, PHB first formed regular spherulites. Their growth started from outside the PVDF dendrites but could later interpenetrate them, and this made their own morphology dendritic. These PHB spherulites melted stepwise because the lamellae inside the PVDF dendrites melted at a lower temperature than those from outside. This reflected the regularity of the two fractions of the lamellae because that of those inside the dendrites of PVDF was controlled by the intraspherulitic order of PVDF, whereas that from outside was only controlled by the temperature and the melt composition. The described morphologies developed without mutual nucleating efficiency of the components. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 873–882, 2003